ATTENTION: All Postings that advertise items for sale will be deleted from the Discussion Forum. You may post sale items for free in the Classifieds section. Sign up now.
Does anyone have a wiring diagram for a 1992 Dodge Ram 250 fullsized van witha 318. I need one desperately. Please e-mail it to me at aquariumking@gt.rr.com HELP!!! Thanks to all. Please hurry.
1992 dodge ram van replaced computer a year ago due to fuel relay clicking wouldnt start until the check engine light comes on,less than a year later it is doing the same.what would cause my computer to keep going out i feel like putting the camp fire to this beast but when its not having problems its a good running buggy.any help would be appriciated greatly.thank u
Dodge van wont start untill fuel relay starts making noise.and the check engine light gradually gets brighter then it turns fully red and 1992 dodge ram van fires upafterred light goes off,what is this problem?
I have a Dodge Ram 250 1992 conversion van and the Fuel gauge is not working, can anyone tell me what the problem might be, when i go over a bump the gauge flickers and when i press down on the brake hard it kinda tells me how much fuel i have in tank...please please some one help !!!!!!!!
MY VAN JUST HAD A TUNE UP AND A FUEL PUMP REPLACED, BUT IT HESITATES SOMETIMES TRYING TO START UP.IT WILL RUN NICE,BUT EVERY NOW AND THEN IT WILL STALL STARTING WHEN TURNED OFF. COULD IT BE MY FUEL FILTER OR A BAD PUMP INSTALLED, IT ALSO JERKS WHEN REACHING 70 MILES PER HR.
Need a wiring diagram for a 1992 dodge ram fuel relay system. i put a brand new pump in the truck and now i think its the relay according to the dealer. need a diagram showing me where the relay is locate at.its a 1992 dodge ram 150 full size pickup automatic 4x4 limited edition 318 engine
Hi there,can you Email me a copy of a dodge van electrical wiring diagram,both the driver department and the engine compartment wiring diagram.thank you
I am having trouble with getting spark. I have had the coil tested (ok) changed the computer, changed the distrubtor cap, rotor and pickup module and stll ahve no fire everything else works. It pumps fuel and turns over but has no spark. I NEED HELP!!!
The blower motors both front and rear have just quit. I am wondering if there is a fusable link somewhere as the fuses are fine. How is voltage sent to the fan. From the push pull set of switches for air and heat right?
I have a 92' plymouth that I am trying to install a cd player into. However, I am the third owner of the van and the original owner removed the factory installed radio and replaced it with a cassette deck/radio. My problem is that he split the wires. There is no box and I have no idea which wires go where? I have located the power wires (one for cd and the other for the clock unit), but I have never done this before and am utterly frustrated.
I have a charging system problem, It
charges 14.3-14.9 volts when cold but as it warms up the charge rate goes down, to about 12.5 or less up to 13.3
within about 15 minutes and stays there
until it cools down, then will charge up 14.3-14.9 volts again until it warms
up again. I changed the regulator, no
improvement, I changed the alternator,
no improvement. The battery is full charged. This just started about 2 months ago, and I haven't been able to find the problem, Im thinking maybe it could be a broken wire in the circuit?
If I could get a wiring diagram of a 1977 Dodge B-300 maxi-van. I could check the wires for burns or breaks.
Thank you, William.
I am having trouble getting spark. I have changed the coil,rotor, distributer cap, plugs, plug wires, ignition switch, pickup module, and computer, but I still get no spark.
I have a 1992 Dodge Ram 250 van and the engine cut out after running for a few seconds. It will not start now, but cranks over. There is no spark. Before it cut out it was running fine, but the maintenance warning light was on.
Any ideas?
I am looking for a wiring diagram for a 93 Dodge 250 van. The engine will stall while driving down the road and the speedometer will go to zero. After a while it will start however it is getting worse. Is there a set of relays that provide power to the control module?
What should I be looking for?
Thank you,
Gary
My 2002 dodge family van has been running fine until we got road gator and broke speed sensor, Ihave replaced sensor trans. works fine but keeps stalling,key switch is loose and key willcome out in the on pos.how do I change ingnition switch.
I need the wiring schematics for the lighting system, I have no power to my fuse box for the headlights, taillights, brake lights, nothing. Can someone help??
Please, have you the complete wiring diagram for a 1990 or 91/92 dodge half ton Van with a four barrel ( or two barrel ) carb with a 360 engine on it ? I would appreciate if you can send me a copy of the original shema ( because if not, I should buy the complete service book ). Sorry for my poor english, I write to you from Québec.
Have a nice day !
email Todd
reply to message
post new message
search forums
