ATTENTION: All Postings that advertise items for sale will be deleted from the Discussion Forum. You may post sale items for free in the Classifieds section. Sign up now.
I have a Hydro Flame 8500 III, 8900 II
I've taken out every screw and still it wont come out. I have removed any on the backside. It it spot welded in or something?
Turn off propane, remove one screw from the timer relay (has 4 wires going to it on left front cover) loosen the other and pull it loose. Remove 4 screws from the plastic cover it is on and remove the cover, remove the PC board, remove the exhaust tube, take the propane line loose, take the igniter wire(red)loose and one quick disconnect wire (both on propane line side), remove 3 - 4 screws from rear that hold the burner in and one on the round edge, pull out the burner, loosen set screw on the small fan, hold the large fan and rock the small one while pulling to remove it. There are 3 hex screws behind the small fan remove them and you should be able to pull the motor and blower fan out as one assembly. Remove and install fan on new motor, reverse all this to install. You may have to change one wire connector on the new motor to hook it up. Pay attention to where the motor wires were connected as the motor will run backwards if you reverse them. Hope this helps, good luck! Keith Note: this is for II & III series. IV is similar, but the motor is held in with a hose clamp, it isn’t hard to figure out the difference‘s.
I have the Hydro Flame Excalibur 8535-II model and it makes a lot of noise from the fan area. Is there a method to remove and test? If so could some one send me the disassembly procedure? Thanks
Mack
I need the same removal information. I have an Atwood Hydro Flame 8531-III furnace and the fan motor needs lubrication or replacement. Would you please e-mail me the removal/replacement information also?
Thanks very much
Need to replace fan motor in 8535 hydroflame.Also having problem with 13500 A/C unit that kicks breaker sometimes on 30 amp a/c outlet. 4000 watt generator will not run a/c. Thanks
email Walt
reply to message
post new message
search forums
