ATTENTION: All Postings that advertise items for sale will be deleted from the Discussion Forum. You may post sale items for free in the Classifieds section. Sign up now.
The co2 monitor should be inside the coach, but these also is the case of the control board. Call dometic, campers world and a local rv store with the model and ser#'s and get the price on the board. If all the power as you state is good, and as was said above there is no yellow stains from the gas, then try the board, also if that dose not work you most likley will need to replace the fridge as the hole control with gas unit is to expensive to replace.
Good luck
Is the gas on----is the co2 monitor on---does the ignitor click,is their 12 volts there,or while on 115 volt---does the tower get warm--
is their yellow residue outside behind the burner,
lots of variables---from this side of your message
rich in Va.
I have a Dometic 2-way refrigerator and the circuit board seemed to be shorting out. I ordered a new board. At the time the board came the refrigerator was working fine, but I went ahead and replaced the board anyway. Now I cant get the refrigerator to even come on. I s there something I should know about replace a circuit board. What could be the problem.
1997 Dometic 2510 Refrig. does not cool
at all!(on gas)or Electric. tower gets hot, 12volts present, pilot light looks good, coils on back of fridge
not cool or warm? Please Help,
Kurt
Are you getting any codes on the fridge. I had mine quit on me..sounds the same. The tech ended up resetting the board. Had to jump the circuit to reset it. Something about running it for too long when its not level. I had been driving thru the mountains and he said that couldve been it.
I have a Dometic RM1303.My RV experienced some electrical problems causeing all sysytems to fail. It was corrected by updating my transfer switch.However I now have a light for igniting gas or electricalcooling. Refrigerator worked correctly until tranfer switch failure. I show power at ac plug, and 12 volt connections to unit but still no working refrigerator. Is this likely the circiut board ? And where is it located?
Thanks
MY RM1303 FRIDGE WORKS GOOD ON 120V AND AUTOMATICLY STARTS ON PROPANE WHEN I TURN THE CONTROL KNOB TO GAS. IT WORKS OERFECT FOR ABOUT 2 MINUTES THEN THE INDICATOR LIGHT CHANGES FROM SOLID GREEN TO FLASHING RED, PROPANE FLAME IS STILL BURNING AT THIS POINT AND UNIT IS COOLING, AFTER A FEW HOURS THE PROPANE GOES OUT AND UNIT STOPS COOLING,BUT NOT BEFORE IT GETS COLD ENOUGH IN THE FREEZER TO FREEZE A BOTTLE OF WATER AND BRING THE MAIN FRIDGE COMPARTMENT DOWN TO 45 DEG. ANY IDEAS ON WHAT I NEED TO CHECK TO GET THIS FIXED???
email Randy
reply to message
post new message
search forums
