ATTENTION: All Postings that advertise items for sale will be deleted from the Discussion Forum. You may post sale items for free in the Classifieds section. Sign up now.
My 8500-III Hydroflame was working. The next time I used it, kept turning on and off and blowing cold. Now does not turn on or off - flat-lined. It's as if no power. Battery fully charged. Everything else in trailer works. Fuse appears OK, unless there's another one I don't know about. Had circuit board tested OK. What should I try next, thermostat? or something else more obvious first.
Appreciate your assistance,
Virginia
Hi Virginia, First make sure all connections are clean and secure. Could be the circuit breaker on the front of the furnace is tripped, the thermostat is bad, or the timer relay, or motor is bad. Hard to tell from here, but check for a popped circuit breaker first, since you say the fuse is OK. Then disconnect and hold the two blue wires on the furnace side together for 30 sec's or so and see if it works. If it does, change the t'stat. Check for 12V on the positive wire (red) to the motor, with the t'stat up, if 12V and it's not running, probably a bad motor. Good luck.
The sail switch activates the blower. You can hear the click of the electrode and the flame comes on for 5-6 seconds and then shuts itself off. It will do this repeatedly without staying lit. The furnace has run great uo til now. Thank you. Rick
The hydro flame runs but when the heating part cuts in (can feel the heat by the outside vent)4 to 5 seconds later the lil breaker on the blower trips i even turned down the t-stat but it wont stay working.please help its cold out here.