hydro-flame 8500-IV lighting failure

Home > Discussion Forum > Mechanic's Corner (general)

email Keith   reply to message   post new message      search forums

Re: hydro-flame 8500-IV lighting failure by Keith

Hi Orval, Check the fuse on your 12V fuse panel, if ok, with T'Stat up check for 12V at the the circuit breaker/on off switch on the furnace or if it's tripped, if not ok (power), possible bad thermostat or wire loose somewhere, if ok, check for 12V at the power spade connector (PWR) on the circuit board, if ok, check for power from the blower spade connector (BLO) on the board, if ok, bad motor, if not, bad board. Good luck!

All Messages in Thread		Author	Date
	Hydro-flame 8500-IV lighting failure	Orval	5-14-09
	Re: hydro-flame 8500-IV lighting failure	Keith	5-14-09
	Re: hydro-flame 8500-IV lighting failure	Ken Ibbetson	1-20-10

Required fields in red For more info about a field, place your mouse over the icon.
	Subject:
	Your Name:
	Your Email:
	Message: Type Code in box: Code is case-sensitive. Helps stop SPAM.